|LOGGING AND THE USE OF RIVERS
There were two phases in the lumbering operations in Michigan. In the first of these,
river logging, the timber was floated down the streams to the mills. The area which could
be tapped by this method was limited to that within easy reach of the main rivers and
their principal tributaries. In the second phase the railroads
replaced the river as the main carriers, and, since logging branches could be
constructed almost everywhere, this effectively cleaned up the rest of the merchant
River logging was primarily a winter business. Only when the swampy
ground had frozen over and ice covered the roads could logs be handled with minimum
expense. The crew went into the woods in September and established a camp at a spot
convenient to the area marked for logging. From that time until the beginning of winter
the primary job was the construction of roads.
These roads had to be not less than 25 feet wide, without steep grades
and free from all obstructions. Streams were bridged and swamps spanned by roads of logs
called "corduroys". The easiest grades (i.e., slopes) were along the creek
bottoms where, unfortunately, soft ground, piles of windfalls, vines, and bushes made road
building most difficult. On the uplands the roads wound through the timber following the
easiest grades and penetrating all parts of the district to be logged. At intervals along
the road small square clearings were cut where the log piles would be established. When
the actual cutting had started, narrow trails were made back from the roads through the
timber. These were the "travoy" (travois) roads, or skid trails over which the
cut logs were "snaked" out to the skidways.
In order to
process the timber, most cut logs had to be transported to rivers, and then down those
rivers to sawmills. There were rare occasions when there
was not enough water to float the logs, and in those years pine logs left in the woods
would rot or be destroyed by fire.
The early sawmills and lumbering centers were, therefore, mainly
situated at the mouths of rivers, which made harvesting the nearby timber a relatively
easy and efficient task. Communities such as Muskegon (1837), Traverse City (1850), and
Menominee (1865) owe their existence to the logging boom. As the coastal supplies were
depleted, cutting operations moved upstream and inland, and interior mill towns like
Cadillac, Roscommon, and Grayling were founded.
Before logs entered the river, there was preparation work. An efficient drive required the
waterway channels to be cleared of rocks and trees that might catch logs and create a
dreaded jam. Often dams were built in the headwaters to control the flood stages, so that
a series of artificial freshets might be available to carry logs, rather than one big
natural flood that might leave some of the valuable timber behind to wait for the next
The second of the logging operations which has left its traces upon the
landscape was the clearing of the streams for the "drive" when, upon the high
water of spring, the logs would be floated down to the mills. The debris of centuries of
floodwater choked the streams; old snags and stumps lay imbedded in the ooze; decayed
trunks, moss-grown, blocked the current and all of this had to be removed. In some places
the carrying capacity (i.e., flow) of the stream was increased by a series of dams. Along
the stream banks were constructed very large skidways called "rollways"
on which the logs were piled ready to roll into the stream when the drive began.
Rollways were dangerous places--when the logs came toppling down, many a man lost a limb
or even his life.
Sometimes the lumberjacks built log slides, like the one shown below, to facilitate the
transport of logs from the uplands to the river.
Before the logs were to be sent downstream, however, each had to be
identified by owner. To do this, log marks, each one different for each different
logging company, were affixed to the ends of the logs (similar to the cattle brands used
in the West). The design of a log mark might include the initials of the lumber company's
owner or symbols from the logging industry or from nature. The designs were cast into the
metal end of a marking hammer by a blacksmith. The symbols needed to be simple, clean
designs so the person who struck the log with the marking hammer could cut the design
easily into each log. According to an 1842 Michigan law, the marks had to be
registered in the county of the logs' destination (usually the location of the sawmill).
These are some Michigan log marks with the name of the person who registered each and the
year and county of registration: Examples of such marks are shown below.
Once marked, chutes or rollways such as the one below on the Manistee River,
were used to get the logs to the water. Logs would be piled up at the top of the
chute all winter long, and then when the spring floods came, the logs would be
chuted/rolled down into the river. Where chutes did not exist, the logs would simply
be piled up neatly on a high bank (below), and then at an appropriate time, the bottom
logs would be pulled out and the entire pile would go rolling down to the river.
The log drive was the most exciting and picturesque of the logging
operations. The logs went down the stream, in many cases for a hundred miles of more, but
not always smoothly or easily. A few logs would catch on an obstruction or on one another;
more would follow in, and soon a log "jam" was formed.
In some places this could be blasted loose, in others, the courageous lumber jacks would
pick out the "key logs" until the whole thing gave way. The men followed along
with the drive keeping the timber moving and riding on the logs. There was much to do; the
logs would drift out of the current and become stranded, dams and sluices had to be
passed; jams formed and were broken. The work lasted from dawn until dark. At the rear of
the drive came the cook's clumsy flatboat.
As you can imagine, dry weather (especially low-snow winters) had
potentially devastating affects on river and lake levels. During the lumbering era these
issues developed into "traffic" problems. The biggest headache for moving logs
down river was low water levels. Delays that played most havoc with log transport were
those due to lack of water for flotage. When it was dry and water was down, great
difficulties were experienced in driving logs downstream. This caused many mills to sit
idle, and some lumber companies to go out of business.
Finally, however, the logs floated into the quiet water of the mill
booms, the men were paid off and another drive started -- this time toward the saloons.
The end point of all this effort was the sawmill, typically
located at the mouth of the river, on the Great Lakes.
One of the more famous of the many "lumber barons" in Michigan was Charles
Hackley, of Muskegon (below). Although he amassed great wealth via his lumbering
operations, much of this money he gave back to the city of Muskegon for schools,
hospitals, and the like.
Hackley's mansion in Muskegon.
This material has been
compiled for educational use only, and may not be reproduced without
permission. One copy may be printed for personal use. Please contact
Randall Schaetzl (email@example.com)
for more information or permissions.